MYTURNYET WIKI

Border Loop: rules and a first deduction

Join the edges into one loop

Draw one closed loop along the grid edges. A numbered square tells you how many of its four sides belong to the loop. A blank square has no number requirement; it is not the same as a zero.

The loop must stay connected. It cannot branch, cross itself or split into separate small loops. At each point it visits, exactly two lines meet.

Begin with zeroes and threes

A 0 means none of that square’s four edges can be used. A 3 means exactly three must be used, leaving one out. Mark what you can rule out before deciding which uncertain edges to draw.

Suppose a square marked 3 already has one side ruled out. All its other sides must be part of the loop. If two sides were ruled out, the current marks would be impossible: check an earlier decision.

Continue through a point

If one line enters a point and all exits but one are ruled out, the remaining exit must be used. If two lines already meet there, no third line may be added. These local checks help build a loop without guessing its whole shape at once.

Do not finish too early

A small closed loop may satisfy nearby numbers while leaving other required lines outside it. Before closing a loop, check whether all numbered squares can be satisfied by that same loop. Two separate loops do not make a solution.

This guide uses general deductions, not today’s answer. Try the practice board on the game’s introduction, then play Border Loop. You can begin without an account.[1][2]

Sources

  1. [1] https://myturnyet.com/daily-challenges/slitherlink — Public introduction gives numbered-edge and single-loop goal; blank-clue, vertex and connectivity conditions checked in released Slitherlink engine. No run was started.Checked 2026-10-10 · Confirmed ↩
  2. [2] https://myturnyet.com/api/v1/daily-challenges — Public registry lists Border Loop and anonymous result registration.Checked 2026-10-10 · Confirmed ↩

Browse games